UPS 19000 Standard Resin & Hardener

Rate this item
(4 votes)

THISTLEBOND LOGO-trans-med

Product Description

UPS 19000 is a high performance, epoxy system designed for on-site repairs to metal, wood, glass and synthetic materials.

UPS Epoxy Standard Repair UPS 19000 consists of a unique blend of epoxy resin combined with polyamino amine

adducts, which have been specifically selected to provide the optimum adhesions and mechanical and physical strength.

 

Product Features

 

• Combines good application characteristics with excellent

corrosion protection and chemical resistance.

• Adhesion - Excellent to both blast cleaned and

mechanically prepared surfaces.

• Corrosion Resistance - Excellent even under sea water

immersion conditions.

• Chemical Resistance - Unaffected by short term contact

with industrial chemicals.

• Temperature Resistance - Suitable for use up to 100°C dry

heat.

 

General Application Steps

1. Remove loose material, rust and surface contaminants,

including existing coatings.

2. Appropriately prepare the surface using a needle gun,

angle grinder or abrasive blasting.

3. Apply UPS 19000 as

required.

4. Allow to cure.


Properties
Ratio 2:1 by volume
Drying & Cure times at 20°C (68°F)
Touch Dry 2 hours
Hard Dry 16 hours
Minimum Overcoating 2 hours
Maximum Overcoating 24 hours
Full Cure 7 days
Volume Solids 100%
Specific Gravity (Average Mixed)  - 1.08
Film Thickness (Typical) Wet/Dry 100 microns.
Note: The actual thickness to be applied should be agreed between the specifier and the manufacturer dependant on operational performance criteria and may be higher or lower than the quoted typical value.

 

Theoretical Coverage Rate 0.6 sq metres per unit at 200 microns dft.

 

 

 CHEMICAL REISTANCE CHART FOR UPS 19000
 VIDEO DEMONSTRATION
TECHNICAL DATA SHEET

 

 

 


 

 

Read 26694 times Last modified on Wednesday, 29 January 2014 16:28