UPS 210 CR EFFICIENCY FLUID CERAMIC is a high-performance solvent free epoxy coating designed for use as a resurfacing and lining system to improve the efficiency in fluid flow environments whilst providing outstanding long-term erosion and corrosion protection.
The material can be applied directly to abrasive blasted steel surfaces or to surfaces which have been previously rebuilt with UPS 105 EG THISTLEBOND METAL REPAIR PASTE or UPS 200 EG CERAMIC REPAIR PASTE.
Equipment refurbished using UPS 210 CR has shown an increase in efficiency by 10%, ultimately saving valuable asset downtime.
Excellent application characteristics
Improves fluid flow efficiency through process equipment
No hot work required – Application and cure at ambient temperature
Excellent chemical resistance
Outstanding long-term erosion and corrosion protection
Solvent free material – Reducing Health & Safety concerns
No shrinkage, distortion or expansion
Formally known as
TR 210 / Cerami-Tech CR / 511 CR
Applications for UPS 210 CR EFFICIECNY FLUID CERAMIC include:
Pump cases and impellers
Water boxes
Kort nozzles
Ship hulls
Jet tubes
Pipes
Heat exchangers end plates
Bow thrusters
Propellers
Rudders
Valves
Brush or Applicator
Tool Applied
20 minute Usable Life at 20°C (68°F)
Dry Heat Resistance in Excess of 200°C (392°F)
Surface Preparation
Manual | Mechanical | Abrasive Blast
Compressive Strength
(ASTM D695)
735KG/cm² (10,450 psi)
Abrasion Resistance
(Taber CS17 Wheels / 1KG Load)
24mm³ loss / 1,000 cycles
Colours Available
Light Grey, Blue & Red
Tensile Shear Adhesion
(ASTM D1002 Abrasive Blasted Mild Steel with 75 microns Profile)
187KG/cm² (2,650 psi)
Useable Life
20 mins @ 20°C (68°F)
Pack Sizes
1KG (2.2LB) | 3KG (6.6LB)
1KG (2.2LB) of fully mixed product will give the following coverage rates -
3.235m² at 200 microns 34.77ft² at 8 mil
2.188m² at 300 microns 23.52ft² at 12 mil
Please note that the coverage rates quoted are theoretical and do not take into consideration the profile or condition of the surface being repaired
Suitable for long-term water immersion at temperatures up to 70°C (158°F)
Resistant to dry heat in excess of 200°C (392°F) dependent on load
The product demonstrates resistance to a wide variety of inorganic acids, alkalis’, salts and organic media
If the chemical is not listed, please refer to the Unique Polymer Systems Technical Centre for advice
Email: sales@uniquepolymersystems.com or call +44 (0) 1531 636 300
USDA Compliant for incidental food contact
