UPS 226 HAC HIGH ACID CERAMIC has been designed to upgrade and enhance the performance of metal surfaces with long-term erosion and corrosion protection in combination with excellent chemical resistance.
UPS 226 HAC will protect process operating equipment in contact with high aggressive acids and chemicals at elevated temperatures.
Resists up to 110°C (230°F) in continuous immersion
Designed for application by brush or squeegee
Exhibits excellent adhesion to correctly prepared metal surfaces
Excellent chemical resistance
High compressive strength
Outstanding long-term erosion and corrosion protection
Primarily designed for resurfacing and lining metal components
No shrinkage, distortion or expansion
Can be applied in a single coat at 700-900 microns
No hot work required –
Application and cure at ambient temperature
Applications for UPS 226 HAC HIGH ACID CERAMIC include:
Sour oil and gas processing equipment
Acid treatment vessels
Chimneys etc
Scrubber units
Extraction fans
Brush Applied in 2 Coats
Full loading 1.5 days
Wet Heat
Resistance up to 110°C (230°F)
Surface Preparation
Manual Mechanical | Abrasive Blast
Compressive Strength
(ASTM D695)
983KG/cm² (13,960 psi)
Abrasion Resistance
(Taber CS17 Wheels / 1KG Load, Wet)
85mg loss / 1,000 cycles
0.036cc loss / 1,000 cycles
Colours Available
Light Grey, Dark Grey
Tensile Shear Adhesion
(ASTM D1002 Abrasive Blasted Mild Steel with 75 microns Profile)
220KG/cm² (3,125 psi)
Useable Life
25 minutes @ 20°C (68°F)
Pack Sizes
1KG (2.2 LB) | 3 KG (6.6 LB)
1KG (2.2LB) of fully mixed product will give the following coverage rates -
1.415m² at 300 microns 15ft² at 12mil
1.063m² at 400 microns 11.5ft² at 16mil
0.850m² at 500 microns 9ft² at 20mil
0.708m² at 600 microns 7.5ft² at 24mil
0.607m² at 700 microns 6.5ft² at 28mil
Please note that the coverage rates quoted are theoretical and do not take into consideration the profile or condition of the surface being repaired
Suitable for use in immersed conditions at temperature up to 110°C (230°F)
Resistant to dry heat up to 240°C (464°F) dependent on load
The product demonstrates resistance to a wide variety of inorganic acids, alkalis’, salts and organic media
If the chemical is not listed, please refer to the Unique Polymer Systems Technical Centre for advice
Email: sales@uniquepolymersystems.com or call +44 (0) 1531 636 300
