UPS 242 HDX-T HEAVY DUTY CERAMIC-T has been specially developed to resurfacing equipment subject to sever abrasion.
UPS 241 HDX-T is exceptionally suitable for extreme impact and sliding abrasion environments from aggregates and wet slurries.
Excellent adhesion to correctly prepared metal surfaces
Ideal for fluid with high solids content
Will not corrode
High mechanical strength
Long working life
Designed for application by trowel or spatula at thickness up to 6mm (240mil)
Solvent free allowing for application in confined spaces
No hot work required –
Application and cure at ambient temperature
Applications for UPS 242 HDX-T HEAVY DUTY CERAMIC-T include:
Slurry pumps
Buns & hoppers
Fan blades & housings
Internal pipe surfaces
Wear plates
Pipe elbows, chutes
Transport screws
Pulverizes
Ceramic tile lined chutes
Useable Life
50 minutes
Cost Effective
Solution
Wet Heat Resistance up to 60°C (140°F)
Surface Preparation Mechanical | Abrasive Blast
Corrosion Resistance
(ASTM B117)
Minimum 1,000 hours
Compressive Strength
(ASTM D695)
790KG/cm² (11,150 psi)
Colours Available
Grey
Tensile Shear Adhesion
(ASTM D1002 Abrasive Blasted Mild Steel with 75 microns Profile)
236KG/cm² (3,300 psi)
Useable Life
50 minutes @ 20°C (68°F)
Pack Sizes
5KG (11LB)
5KG (11LB) of fully mixed product will give the following coverage rates -
0.35m² at 6mm 3.76ft² at ¼”
0.21m² at 10mm 2.26ft² at 0.4”
Please note that the coverage rates quoted are theoretical and do not take into consideration the profile or condition of the surface being repaired
Resistant to dry heat in excess of 150°C (302°F)
Pass (ASTM D2485)
Full immersion resistance;
Tested water / hydrocarbon immersion to 60°C (140°F)
Pass (No blisters)
The product demonstrates resistance to a wide variety of inorganic acids, alkalis’, salts and organic media
If the chemical is not listed, please refer to the Unique Polymer Systems Technical Centre for advice
Email: sales@uniquepolymersystems.com or call +44 (0) 1531 636 300
