Ultimate Epoxy Novolac 75 –
Brush & Airless Spray
UPS 403 UCU-BGSG ULTIMATE EPOXY NOVOLAC 75 - BRUSH & AIRLESS SPRAY is an extended pot life solvent-free high functionality epoxy novolac coating.
Designed for application in hot climates and to provide outstanding chemical and corrosion protection of steel and concrete structures at elevated temperatures.
The coating has been designed to be applied by roller, brush or standard airless spray equipment and once cured will resist high concentration chemicals such as 98% sulphuric acid at immersion temperatures up to 75°C (167°F).
Solvent free epoxy novolac – Reducing Health & Safety concerns
Resistant to 98% Sulphuric Acid & 36% Hydrochloric Acid at 75°C 167°F) in continuous immersion
Suitable for all metallic substrates
Acid & chemical protection up to 90°C (194°F)
Applied in 2 coatings using standard airless spray to achieve 1000 microns DFT
Applications for UPS 403 UCU-BGSG ULTIMATE EPOXY NOVOLAC 75 - BRUSH & AIRLESS SPRAY 75 include:
Chemical resistant coating for bunds, secondary containments, chemical spill areas, tank plinths etc.,
Protection of pumps, valves fittings etc.,
Protection of chimneys
Chemical drains and channels
Protection of concrete areas subject to aggressive chemicals – Pump bases
Tank lining system
Airless Spray Applied
Brush or Roller Applied
Water / Sea Water Immersion in 4 days
Wet Heat Resistance up to 90°C (194°F)
Useable Life
45 mins @ 20°C (68°F)
Water / Sea Water Immersion
4 days @ 20°C (68°F)
Corrosion Resistance
(ASTM B117)
Minimum 5000 hours
Available Colours
Grey | Red
Minimum Over-Coating Window
8 hours @ 20°C (68°F)
Flexural Strength
(ASTM D790)
810KG/cm² (11,500 psi)
Flexural Strength
(ASTM D790)
810KG/cm² (11,500 psi)
Compressive Strength
ASTM D695
901KG/cm² (12,800 psi)
Pack Sizes
4LTR (1.1 US Gallon) | 16LTR (4.2 US Gallon)
4LTR (1.05 US Gallon) of fully mixed product will give the following coverage rates -
8m² at 500 microns 85ft² at 20 mil
16LTR (4.2 US Gallon) of fully mixed product will give the following coverage rates -
32m² at 500 microns 343ft² at 20mil
Please note that the coverage rates quoted are theoretical and do not take into consideration the profile or condition of the surface being repaired
When post-cured suitable for use in immersed conditions in mineral acids at temperatures up to 90°C (194°F), hydrocarbons up to 105°C (221°F)
Dry conditions up to 200°C (392°F) dependent on service.
The product demonstrates resistance to a wide variety of inorganic acids, alkalis’, salts and organic media.
If the chemical is not listed, please refer to the Unique Polymer Systems Technical Centre for advice.
Email: sales@uniquepolymersystems.com or call +44 (0) 1531 636 300
