UPS 909 PP-XL POROUS PRIMER - EXTENDED LIFE is an extended life version of the standard UPS 909 PP making it more suitable for warmer climates or more complex applications where more time is necessary.
Solvent free epoxy technology
Apply by brush, roller or standard airless spray
Extended cure version of UPS 909 PP –
Suitable for warmer climates
Cures at temperatures down to 5°C
No shrinkage
Applied in 1 or 2 coats at 100-125 microns per coat
Applications for UPS 909 PP-XL POROUS PRIMER - EXTENDED LIFE include:
Priming porous surfaces such as concrete
Floors, tank linings, bunds, secondary containment areas
Surface Preparation Manual | Mechanical | Abrasive Blast
Brush or Roller Applied
Useable Life 90 minutes
Airless Spray Applied
Useable Life
50 minutes @ 20°C (68°F)
Minimum Over-Coating Window
8 hours @ 20°C (68°F)
Compressive Strength
(ASTM D695)
629KG/cm²
(8945 psi)
Pull off Adhesion
Dry
37KG/cm²
(525 psi)
Wet
33.4KG/cm²
(475 psi)
Available Colours
Amber
Shore D Hardness
(ASTM D2240)
84
Maximum Over-Coating Window
36 hours @ 20°C (68°F)
Flexural Strength
(ASTM D790)
371KG/cm²
(5275 psi)
Tensile Shear Adhesion
(ASTM D1002)
(Abrasive Blasted Mild Steel with 75 micron profile)
Mild Steel
201KG/cm²
(2860 psi)
Rusted Steel
167KG/cm²
(2375 psi)
Pack Sizes
4LTR | 18LTR
4 LTR (1.1 US Gallon) of fully mixed material will give the following coverage rates -
26.6m² at 150 microns
286ft² at 6mil
18 LTR (4.75 US Gallon) of fully mixed material will give the following coverage rates -
119m² at 250 microns
1280ft² at 10mil
Please note that the coverage rates quoted are theoretical and don't take into consideration the profile or condition of the surface being repaired
Suitable for use in immersed conditions at temperature up to 60°C (140°F)
Resistant to dry heat up to 150°C (302°F) dependent on load
