UPS 782 HAE HEAT ACTIVATED EPOXY is a single component solvent free heat activated epoxy coating which is activated at temperature above 100°C and can resist high corrosive environments up to 200°C.
UPS 782 HAE is ideal for the protection of surfaces where Corrosion Under Insulation (CUI) is prevalent.
UPS 782 HAE can easily be applied by brush and does not require any mixing or weighing prior to application. The material is applied onto hot surfaces with minimal surface preparation, avoiding production downtime. Once cured it provides excellent corrosion protection.
Applied in 2 coats at 250-300 microns per coat
High adhesion to metals, polyethylene and polypropylene
Provides long term roof protection Good chemical resistance to a wide range of industrial chemicals
Fast curing so re-insulated with minimum delay
Apply by brush or airless spray
Advance curing system -
Applied at temperatures ranging from 100°C to 200°C
Solvent free material – Reduced Health & Safety concerns
Excellent corrosion protection
Applications for UPS 782 HAE HEAT ACTIVATED EPOXY include:
Hot pipework, process vessels, tanks etc.,
Long term corrosion protection of hot equipment
Surface Preparation Mechanical | Abrasive Blast
Touch Dry 2 hours
Apply at Temperatures Ranging Between
100 – 200°C
Brush / Roller / Airless Spray Applied
Tensile Shear Adhesion
(ASTM D1002)
197KG/cm² (2,800 psi)
Available Colours
Red
Corrosion Resistance
(ASTM B117)
Minimum 1,000 hours
Pack Sizes
4LTR
Resistant to dry heat up to 100°C (212°F) dependent on load
TABLE NEEDED
Cure times are dependent on the cure temperature as dictated in the table below.TempTouch DryLight LoadingFull Loading100°C (212°F)50 mins2 hrs24 hrs110°C (230°F)35 mins70 mins16 hrs120°C (248°F)25 mins50 mins12 hrs130°C (266°F)15 mins30 mins8 hrs140°C (284°F)7 mins15 mins6 hrs150°C (302°F)3 mins7 mins4hrs
Refer to the Unique Polymer Systems Technical Centre for advice.
Email: sales@uniquepolymersystems.com or call +44 (0) 1531 636 300
4 LTR (1.25 US Gallon) of fully mixed material will give the following coverage rates -
16m² at 250 microns 172ft² at 10mil
Please note that the coverage rates quoted are theoretical and do not take into consideration the profile or condition of the surface being repaired
The product demonstrates resistance to a wide variety of inorganic acids, alkalis’, salts and organic media
Refer to the Unique Polymer Systems Technical Centre for advice
Email: sales@uniquepolymersystems.com or call +44 (0) 1531 636 300